Impact of atmospheric pressure plasma treatment on surface metallization of CFRP composites

Logo poskytovatele

Varování

Publikace nespadá pod Pedagogickou fakultu, ale pod Přírodovědeckou fakultu. Oficiální stránka publikace je na webu muni.cz.
Autoři

RAFAILOVIĆ L. D. STUPAVSKÁ Monika PRYSIAZHNYI Vadym POLT G. ROHR O. NIXON S. RÁHEĽ Jozef

Rok publikování 2021
Druh Článek v odborném periodiku
Časopis / Zdroj Surface and Coatings Technology
Fakulta / Pracoviště MU

Přírodovědecká fakulta

Citace
www https://doi.org/10.1016/j.surfcoat.2021.127046
Doi http://dx.doi.org/10.1016/j.surfcoat.2021.127046
Klíčová slova non-thermal plasma pretreatment; post-plasma surface processes; DCSBD; carbon fiber reinforced polymers; Cu metallization
Popis Carbon fiber reinforced composites (CFRP) were activated by atmospheric pressure plasma source to improve the performance of galvanically plated Cu layer on its surface. Plasma activation was done by use of diffuse coplanar surface barrier discharge. Owing to its fabric structure, the morphology and chemical composition of CFRP structure is inherently heterogeneous. Therefore, the attention has been paid to mutual comparison of plasma induced chemical changes and the actual performance of metalized layers at morphologically distinct areas of CFRP surface. To evaluate these performances the XPS, FTIR, determination of surface free energy, nanoindentation, SEM and scratch tests were employed. The chemical analysis confirmed that the positive effect of plasma pre-treatment can be attributed to the introduction of the polar oxygen containing groups: -C=O and -O-C=O into the thin topmost epoxy resin areas, and –C-OH into thick inter-yarn epoxy resin areas. The results also showed that optimized plasma activation can mitigate the adhesion differences between the distinct surface structures.
Související projekty:

Používáte starou verzi internetového prohlížeče. Doporučujeme aktualizovat Váš prohlížeč na nejnovější verzi.